Photomultiplier Power Supply-1200V 3.6W|Genvolt Photo-PM - Bespoke Photomultiplier Power Supply
Genvolt have designed and manufactured a large variety of power supplies to meet a multitude of requirements. These power supplies were designed specifically for individual customers and whilst they are not available as 'off the shelf' products we are able to use these designs and others to create a tailor-made solution to your high voltage requirements.
This photo-multiplier power supply has been designed with scientific instrumentation in mind. In order to produce spike free output with low ripple and high stability, linear circuit topology has been employed. Control is via 22 turn potentiometer or 0 to 10V input. A 10 volt stable reference output is available at the connector.
|Input voltage||24 to 30VDC recommended. Current consumption is 0.4A typically at full load|
|Output voltage||50V to 1200V negative|
|Output current||3mA maximum load current|
|Control voltage||10V input gives - 1200V output|
|Output ripple||Less than 10mV peak to peak at full output|
|Line regulation||Better than 50ppm/volt|
|Load regulation||Better than 50ppm/volt|
|Pin 1||Monitor point|
|Pin 2||Power ground|
|Pin 3||Internal 10V reference output|
|Pin 4||Remote shutdown|
|Pin 5||Power input|
|Pin 6||Variable reference output|
|Pin 7||Control 0V reference|
|Pin 8||HV control input|
|Pin 9||Power ground|
- Typically better that 50ppm/˚C
- The connector is a PCB-mounted 'D' type, male
- Mounting is by means of small flanges at the ends with 4mm clearance holes. The holes are positioned centrally, 158mm apart.
- The unit is finished in Alochrom 1200 and the heatsink anodised, the cover is galvanised steel.