AF06 ESP Power Supply600W To 1000W
The AF06 Range is a highly compact and efficient, mains powered ESP Power Supply (Electrostatic Precipitator). The primary application for this high voltage power supply is for air purification or oil purification by removal of fumes.
The Genvolt AF06 has a precise, stable and adjustable output voltage and output current, enabling an exacting control of the application environment. Built in accordance with our exacting standards it is safe and reliable, with a high tolerance to the noise generated by electrical discharges.
Being versatile it is also suitable for other general purpose applications such as;
- Laboratory Applications
- Electrostatic Applications
- Capacitor Charging
Our AF06 ESP Power Supplies are designed as single output by default, however the dual output power supplies are also available upon specific request.
|Input voltage||220VAC (200VAC - 240VAC)|
|Input current||Less than 6A|
|Output voltage range||10kV to 60kV|
|Power range||600W, 800W and 1000W|
|Output polarity||Positive or negative. Please specify when ordering.|
|Line regulation||Less than 0.5%|
|Load regulation||Less than 0.5%|
|Voltage ripple||Less than 1% at full load.|
|Temperature drift||300ppm/°C maximum when operating under 55°C.|
|Short circuit protection||In the event of an output short circuit, the output current will remain at the set value.|
|Over-current protection||In the event of an output over-current, the output current will remain at the set value.|
|Spark protection||When the power supply experiences a spark on the load, the output will be switched off momentarily. After which, it will be restored automatically.|
The power supply can be controlled by connecting to 9 way D type female connector or a 10 way IDC connector at the rear.
|Operating temperature||-10°C to 50°C|
|Storage temperature||-20°C to 80°C|
|HV output connector||On one side of the power supply||Mounted on the back panel||Mounted on the back panel|
|Control interface connector||9 way D type female connector (Optional: 10 way IDC connector)|
|Power input connector||Standard 3 way PCB terminal socket & plug 7.62mm pitch.|
This power supply contains hazardous voltages and stored energy. Contact with the output may result in fatal injury. It should only be used and maintained by trained personnel.
- The area where the power supply is to be used should be kept clean and dry.
- Keep a safe distance from the output connector and remove any item which may come in to contact with the output.
- Ensure that a secure connection is made between the Earth side of the load and the green and yellow Earth lead.