AF06 High Voltage Power Supply|600W,800W,1000W|Genvolt High voltage Air/Oil Fume Purification Power Supply
The AF06 Range is a highly compact and efficient, mains powered high voltage power supply. The primary application is for air or oil fume purification. It is also suitable for other general purpose application.
The AF06 has a precise, stable and adjustable output voltage and output current. It is safe and reliable, with a high tolerance to the noise generated by electrical discharges.
The power supplies are designed as single output by default. The dual output power supplies are also available when customer specified.
|Input voltage||220VAC (200VAC - 240VAC)|
|Input current||Less than 6A|
|Output voltage range||10kV to 60kV|
|Power range||600W, 800W and 1000W|
|Output polarity||Positive or negative. Please specify when ordering.|
|Line regulation||Less than 0.5%|
|Load regulation||Less than 0.5%|
|Voltage ripple||Less than 1% at full load.|
|Temperature drift||300ppm/°C maximum when operating under 55°C.|
|Short circuit protection||In the event of an output short circuit, the output current will remain at the set value.|
|Over-current protection||In the event of an output over-current, the output current will remain at the set value.|
|Spark protection||When the power supply experiences a spark on the load, the output will be switched off momentarily. After which, it will be restored automatically.|
The power supply can be controlled by connecting to 9 way D type female connector or a 10 way IDC connector at the rear.
|Operating temperature||-10°C to 50°C|
|Storage temperature||-20°C to 80°C|
|HV output connector||On one side of the power supply||Mounted on the back panel||Mounted on the back panel|
|Control interface connector||9 way D type female connector (Optional: 10 way IDC connector)|
|Power input connector||Standard 3 way PCB terminal socket & plug 7.62mm pitch.|
This power supply contains hazardous voltages and stored energy. Contact with the output may result in fatal injury. It should only be used and maintained by trained personnel.
- The area where the power supply is to be used should be kept clean and dry.
- Keep a safe distance from the output connector and remove any item which may come in to contact with the output.
- Ensure that a secure connection is made between the Earth side of the load and the green and yellow Earth lead.